Workflow
In general, measurements can have three diffferent states:
Open
Either values are missing or do not qualify for plausibility/consistency. The measurement process itself is not finished yet.
Simulation
The trim check or actual trim is still in progress.
Finished
The trim was good at the time of measurement or considered as finished after trimming.
So you decided to measure your wing's line lengths, as since the last trim check
the number of flight hours specified by the manufacturer has been reached
the period of time specified by the manufacturer has elapsed
you replaced single line(s) or even the whole line set
Have a look on the
toolbar
page first, to get a basic understanding for what the buttons do.
Here are the steps considered the we-measure.io workflow
Start a new measurement for your wing
Measure the wing either directly into we-measure.io or import measurement data from XLSX
After all the values are measured & checked for plausiblity/consistency, continue to simulation
In simulation, use the different tools to check your wing's trim
If you the trim still meets the requirements of the manufacturer, fine! You can just finish the measurement and continue with the last step.
If the trim does
not
meet the requirement of the manufacturer anymore, you should hand it in to a professional check center.
Simulate loop changes and apply necessary loops on your wing
You can split the trimming process in as many steps as you want. To keep overview, just apply the loop changes one by one and re-measure in between.
If you applied any changes
re-measure and continue with step 2
Finish measurement