Will open this wiki.

Connect your BLE laser device.


Laser is connected.

To reset all readings in the current measurement.
This button can also be found besides the title of every group. There you can delete readings for only one group.

Reset changed loops in simulation/result.

Print current measurement/comparison.
In the print dialog you can then either export as PDF or actually print it.

During measurement, all readings are sent and saved to the server.
When editing a draft, all comments, loops and further settings are sent and saved to the server.

During measurement, change measurement presets.
During simulation you can update preselected loops here.

During simulation, change tolerance and offset. The offset will be saved as you finish the measurement, so that the result is easier to read later on.

To create a new draft from a measurement in simulation. The link can then be shared and updated by other users.

To share a finished measurement or measurement in simulation.
During comparison, share the comparison.

These links are accessible to everyone in possession of them. Comments, however, are only visible to logged-in users and only if enabled.

Once the laser is connected, you can start measurement mode here.


If no empty readings are left (the measurement is complete), the button is disabled.

Import measurement from XLSX.


In case you added manual values, the orange color is the hint to import data from XLSX instead of typing one by one.

If no empty readings are left and the data seems plausable, the button is green.


If data is complete, but does contain outliers.

To export readings from simulation/Result.

To start comparing one result with another.


The will cancel comparison and return to the result designated as “After”.

Switch between AoI view and symmetry view in simulation and result.