≪ View Page

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
en:workflow [2025/12/03 08:12] – benjaminen:workflow [2026/04/15 16:14] (current) – [Here are the steps considered the we-measure.io workflow] benjamin
Line 4: Line 4:
   - **Open** <box>Either values are missing or do not qualify for plausibility/consistency. The measurement process itself is not finished yet.</box>   - **Open** <box>Either values are missing or do not qualify for plausibility/consistency. The measurement process itself is not finished yet.</box>
   - **Simulation** <box>The trim check or actual trim is still in progress.</box>   - **Simulation** <box>The trim check or actual trim is still in progress.</box>
-  - **Finished** <box>The trim was either still good or considered as finished (good again).</box>+  - **Finished** <box>The trim was good at the time of measurement or considered as finished after trimming.</box>
  
 ==== So you decided to measure your wing's line lengths, as since the last trim check ==== ==== So you decided to measure your wing's line lengths, as since the last trim check ====
Line 16: Line 16:
  
  
-==== Here is a list of steps to follow so that they match the we-measure.io workflow ====+==== Here are the steps considered the we-measure.io workflow ====
  
   - Start a new measurement for your wing   - Start a new measurement for your wing
   - Measure the wing either directly into we-measure.io or import measurement data from XLSX   - Measure the wing either directly into we-measure.io or import measurement data from XLSX
-  - After all the values are measured & checked for plausiblity/consistency, continue to simulation+  - After all the values are measured & checked for plausiblity/consistency, continue to simulation <alert warning>To trim single lines, stay in the open state, trim and remeasure until you have every line in every group as close to relative zero as possible, then continue to simulation to get an overview about the overall trim</alert>
   - In simulation, use the different tools to check your wing's trim   - In simulation, use the different tools to check your wing's trim
   - If you the trim still meets the requirements of the manufacturer, fine! You can just finish the measurement and continue with the last step. <alert warning>If the trim does **not** meet the requirement of the manufacturer anymore, you should hand it in to a professional check center.</alert>   - If you the trim still meets the requirements of the manufacturer, fine! You can just finish the measurement and continue with the last step. <alert warning>If the trim does **not** meet the requirement of the manufacturer anymore, you should hand it in to a professional check center.</alert>
Line 27: Line 27:
   - Finish measurement   - Finish measurement
  
-<alert info>What if i already finished the measurement and decided to trim it dann doch?</alert>