Aside from the standard view in simulation view, you can select between three different references to get the full picture of your wing.

The first type is referencing on the main lines. This can be achieved by either clicking the name of the main line in the wing view or by checking the radio button next to the name of the desired main line in the value view below.

The selected reference will be indicated with a ref label and marked with a red frame.

For changing to another main line as reference, simply click its name either on wing view or in the value view.

This view allows you to get an idea not only about the angle of incidence in each section of a wing, but also about the symmetry of your wing.

All differences will be shown relative to this selected reference. Deviations in plus direction (lines longer than they should be from the factory setting) are highlighted in red, deviations in minus direction (lines shorted than they should be) are highlighted in blue. The color intensity depends on the selected manufacturers tolerance.

The second reference type you can select is the row. By clicking on a row in the wing view, or by selecting the radio button next to a row in the value view below, you can activate it.

Depending on the number of rows per riser. The line in the AoI diff boxes will also change style to give a better overview.

To see how lines might be different compared to the nominal value within a group, you can simply click on each line in the value view. The referenced suspension point will then be highlighted with a red border.

Differences in plus direction (lines longer than they should be from the factory setting compared to the chosen reference line) are highlighted in red, deviations in minus direction (lines shorter than they should be compared to the chosen reference line) are highlighted in blue.

For this case, the angle of incidence will not be shown.