Simulation overview

In the simulation window, the following elements can be found:

Since in the simulation you are also able to check how changes in the loops will affect the trim of your wing in terms of angle of incidence and symmetry, will reset all the loop changes you did during simulation to how it was set up before measurement.

The shown length changes during simulation depend on the line thicknesses and used maillons. Since we do not have exact values for all wings, this is just a very rough estimation. If you find for your wing larger deviations, please contact us and let us know the right values. We are happy to add them to the line map to improve future simulations.

With you can finish your measurement. From there, you can get the final measurement report which allows e.g. comparison to previous measurements or sharing of the results with other pilots.

The toggle button allows you to switch between AoI view and Symmetry view. By this you can easily see full effects on your trim.

If you would like to know, how the overall length is calculated for each section, click on the

button.

In the setup you can adjust the manufacturer's tolerance. It is, by default, set to 10mm. In case you would like to use a different tolerance, you can adjust it here, either by moving the slider, or by keying in a value in the text field. Changing the tolerance will influence the shown margins in the angle of incidence (AoI) views and also the coloring of the values. (blue for “too short” and red for “too long”).

Through you can export the list of nominal vs. measured values for your further usage in xlsx format.

Whereever you see the icon, you can access additional information by clicking on it.